Why eave systems fail out here on the SE Palouse
Tekoa sits in the far SE Palouse, close enough to Tekoa Mountain and the elevation that comes with it to catch real winter. That means deep snow loads sliding off steep roofs, repeated freeze-thaw swings, and ice dams that form along the eave when warm attic air melts snow that refreezes at the cold edge. Water pushed back under the shingles has to go somewhere, and on an undersized or sagging gutter it spills behind the system instead of through it.
The damage usually shows up in stages: water-stained fascia boards, soft or rotting soffit panels, peeling paint at the eave line, then full board failure where fasteners pull loose. By the time a homeowner notices, the trouble has often spread to the wood it was meant to protect.
Seamless gutters sized for runoff, not just rain
We form seamless aluminum gutters on site in a continuous run, so the only seams are at corners and downspouts - the spots where leaks usually start. For Tekoa's snow and heavy spring runoff we'll often recommend wider 6-inch troughs with oversized downspouts, which carry far more volume than a standard 5-inch profile and clog less readily with needles and grit.
- Proper pitch and hanger spacing so loaded gutters don't sag or pull away under ice weight
- Hidden hangers screwed into solid fascia for a clean line and a stronger hold
- Downspouts routed to move water well clear of the foundation
Soffit and fascia - the wood that does the quiet work
Fascia is the board your gutters hang from; soffit is the underside panel that closes off the eave and lets the attic breathe. In a historic small town like Tekoa, a lot of homes have older dimensional fascia that has soaked up years of overflow and is no longer sound enough to hold a gutter screw. We replace failed boards, correct the eave detailing, and keep soffit venting open so the attic stays cool enough to limit the ice dams that started the problem in the first place.
Where it fits the house, vented aluminum or composite soffit and wrapped fascia cut down the repainting and the rot cycle without changing the lines of an older home.
Done with your roof, not bolted on after
Gutters, soffit and fascia work best when they're planned alongside the roof edge, drip edge and underlayment rather than treated as an afterthought. As a GAF Master Elite contractor - a rating held by only the top 2-3% of roofers nationally - we look at the whole eave as one system. If you're replacing the roof, ask about our offer of a 15-25 year workmanship warranty with a roof replacement, and see how it ties into our roof replacement work.
Local, licensed, and backed in writing
DG Contracting LLC is a family-owned company that has served the Inland Northwest since 2013, and we work right up near the Idaho line where Tekoa sits. We're licensed and insured in both Washington and Idaho, hold a 5.0 rating across 288 Google reviews, and stand behind our work with a 15-25 year workmanship warranty. Flexible financing is available, and estimates are always free.
